Yes, “fishes” is correct: they’re different species. 😉
To start, you’ll need the following for each student: 1 disposable water bottle, 1 12-inch dowel rod, 1 4 x 4 wooden block.
You will also need: scissors (or an exacto knife), masking tape, scrap cardboard, a drill (with a bit the size of your dowel rod), newspaper, flour, water, a hand-mixer, mixing bowl, cheap toilet paper, joint compound, vegetable oil, Elmer’s Glue-All (NOT school glue), modge podge, sponge brushes, tissue paper, large google-eyes, Aileen’s Tacky Glue, and sequins.
First things, first. Remove the outer wrapping, lid, and ring from the water bottle. Drill a hole in your wooden block and push one end of the dowel rod into it. If it’s loose, add a little glue-all to it to help it stay put. Using your scissors (or exacto knife), cut a SMALL slit on the side of the water bottle. Push the other end of the dowel rod all the way into the bottle. If it’s loose, use a piece of masking tape to secure it.
Cut out fish parts from the cardboard, like the fins and tail. Tape those to the water bottle. Rip SMALL pieces (about 2-3 inches) of newspaper, and set them aside.
In a mixing bowl, put about a cup of flour, and add enough water to where it becomes the consistency of pancake batter. Dip a piece of newspaper into the batter and pull it through your index and middle fingers to wipe it off. Press it to the water bottle, and smooth out any wrinkles. Once the water bottle and cardboard pieces are completely covered (make sure to look under it!), let it dry. Add another layer of paper mache.
To create the paper mache clay, remove the toilet paper from the roll, and soak it in a bowl of warm water. Squeeze the water out of it, and pull it apart in very small chunks into a mixing bowl. Add 3/4 cup of Elmer’s Glue-All, 1 cup of joint compound, 2 tablespoons of vegetable oil, and a 1/2 cup of flour. Mix on low for about 20 seconds, then mix on high for about 30 seconds.
Once the fish is dry, smear on the paper mache clay in a VERY THIN layer, smoothing it out as you go. I made sure there were tubs of warm water at each table for when the kids were done. I didn’t want to pour that down the sink. Let the fish dry.
You’re finally ready for the colorful part! Cut small pieces of tissue paper and adhere with modge podge (I made ours by thinning white school glue with water). Let dry.
This one’s ready for the next step: Embellishment!
Add the google-eyes and layer the sequins like scales in some areas. Done! 🙂
This project took us about 6 class periods to finish.